SC-500

めちゃくちゃ3Dプリンターでつくってたりハンドメイドっていう感じの楽器

説明書がついてきたんだけどA4用紙を4つ折りしたのが1枚だけネット上からマニュアルを読めなさそうなので以下に記載

Rule to make sure the unit works properly

1. Use a power bank or wall charger with 2A output.

(No PC or MAC USB port supported, they only provide 0.5A)

2. Do not touch the jog wheel while booting. (it calivrates during the boot sequence)

3. Do not put a sticker or paint on the jog wheel

4. Adding faulty audio files (bad wave forms) or changing the folder structure will cause that the unit does not boot.

5. Do not connnect the USB flash to an iPad

6. If you want to add your own sample and beat audio files then copy them ONLY in the following folders:

Samples: /samples/add your samples in this folder/yoursample.mp3

Beats /beats/add your beats in this foler/yourbeat.mp3

The samples are first sorted by number and then alphabetically. They are played in the same order. If you want a certain file to be played first, you can call it "0.mp3".

Please do not open the device, otherwise you will lose the warranty and any support.

After connecting the USB flash to your Windows PC there might pop up a report that the USB flash is defective.

Do NOT confirm if your PC asks to repair it!

Just open the content of the USB flash via Explorer.

If there are problems with the reaction of the jog wheel or buttons, it is because the device is not receiving the required 2 ampere Make sure your power bank is charged. Use the USB wire that comes with the unit.

Here is short video that explains all functions and how to use them.

Please Scan the QR code to watch the video.

This unit was built and thoroughly tested for all functions by ** and is fully functional.

https://gyazo.com/e9dfa3f4d6efa0359fc0204027f7c272